Design buck converter with variable switching frequency by using matlab simulink simulation

Norazila Binti Md Posdzi(1), Norsa’adah Binti Mahmor(2), Rasidah Binti Abdul Rani(3),
(1) Department of Electrical Engineering, Politeknik Ungku Omar  Malaysia
(2) Department of Electrical Engineering, Politeknik Ungku Omar  Malaysia
(3) Department of Electrical Engineering, Politeknik Ungku Omar  Malaysia

Corresponding Author
Copyright (c) 2020 Norazila Binti Md Posdzi, Norsa’adah Binti Mahmor, Rasidah Binti Abdul Rani

DOI : https://doi.org/10.29210/881201

Full Text:    Language : 

Abstract


This paper presents the design of a buck converter circuit with different input switching frequency by using Matlab Simulink software. This study focuses on defining the suitable value of the inductor and capacitor to be used in the buck converter with 100VDC supply input, where the input switching frequency is use 5kHz and 25kHz. This is because the input switching frequency of a buck converter affects many aspects of circuit functionality. This design of the circuit used 20% of the duty cycle, and inductor value is 25% of Lmin to ensure the operation is in continuous current mode. The evaluation of inductor current and switching frequency used in the circuit and parameters for this analysis based on the output voltage, inductor voltage and inductor current waveform. The design of the circuit verified by simulation and results compared with the theoretical. In addition, the appropriate input switching frequency between 5kHz and 25kHz has been determined in order to use in the buck converter circuit for 100Ω resistive load.

References


Espacios, H. R., & Autores, L. O. S. (2019). Methodology for teaching the buck converter : step by step description of the design. (2005).

Gupta, M., & S. P. Phulambrikar. (2014). Design and Analysis of Buck Converter. 3(3), 2346–2350

Izwan. (2013). Buck Converter Switching Design Using Microcontroller. Universiti Tun Hussein Onn Malaysia.

Lopa, S. A., Hossain, S., Hasan, M. K., & Chakraborty, T. K. (2016). Design and Simulation of DC-DC Converters. International Research Journal of Engineering and Technology, 2395–56.

Rashid, Muhammad (2017), Power Electronic Handbook (4th Edition). San Diego, California: Academic Press.

Robert (2018), How to Choose the Frequency of Your Switching Regulator, Retrieved from

https://www.allaboutcircuits.com/technical-articles/how-to-choose-the-frequency-of-your-switching-regulator/

S.A. Ali, N.A. Riyard, Design of a Non-Ideal Buck Converter Volume 03 Issue 2. International Research Journal of Engineering and Technology.

Wang, F., & Ma, X. (2011). Research on the influence of switching frequency on low-frequency oscillation in the voltage-controlled buck-boost converter. Mathematical Problems in Engineering, 2011. https://doi.org/10.1155/2011/926403

Xiao, Z., Khoa, B. a., & Siek, L. (2017). On-chip reconfigurable switched-capacitor DC-DC converter for indoor PV energy harvesting. Electronics Letters, 53(2), 108–110. http://doi.org/10.1049/el.2016.3018

Xie, H., & Guo, E. (2019). How the Switching Frequency Affects the Performance of a Buck Converter. 1–8.


Article Metrics

 Abstract Views : 0 times
 PDF Downloaded : 0 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Norazila Binti Md Posdzi, Norsa’adah Binti Mahmor, Rasidah Binti Abdul Rani

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.